Details On DTCs

WARNING: This page is about a different variant/trim than selected.

DTC P0457-00: (PCM, VIN M) DETECTION CONDITION AND POSSIBLE CAUSE

DESCRIPTION	Fuel-filler cap installation malfunction
DETECTION CONDITION	Determination conditions	Hole of 0.09 in (2.25 mm) or more in evaporative gas passage
	Preconditions	Evaporative gas flow amount: Exceeds 10, 000 cm³ /min or fuel tank vacuum is high Fuel tank pressure: -4340.2-4030.1 Pa {-442.57-410.94 kgf/m² , -0.62949-0.58451 psi} IAT sensor No. 1: 4.44-43.33 °C {40.0-109.9 °F} Vehicle speed: 64-145 km/h {40.0-90.0 mph}^1 Barometric pressure: 72.23 kPa {0.7365 kgf/cm² , 10.48 psi} or more^1 Period ignition is switched off before engine starts: 210 min or more Fuel level in fuel tank: 15-85 %^1 Minimum value of intake manifold vacuum: 4 kPa {0.04 kgf/cm² , 0.6 psi} or more Minimum value of intake air amount: more than 2 g/sec Battery voltage: more than 11V^1 The following DTCs are not detected: ECT sensor No.l: P0117-00:, P0118-00: TP sensor No.l: P0122-00:, P0123-00: TP sensor No. 2: P0222-00:, P0223-00: Purge solenoid valve: P0443-00: CV solenoid valve: P0446-00: MAF sensor: P0100-00: Fuel tank pressure sensor: P0451-00:, P0452-00:, P0453-00: IAT sensor No. 1: P0110-00: MAP sensor: P0069-00:, P0107-00:, P0108-00: BARO sensor: P2226-00:, P2228-00:, P2229-00: VSS signal: P0500-00: Fuel gauge sender unit: P0460-00:, P0461-00:, P0462-00:, P0463-00: ^*1 : Standard can be verified by displaying PIDs using M-MDS
	Drive cycle
	Self test type	CM DTC self test
	Sensor used	Fuel tank pressure sensor
FAIL-SAFE FUNCTION	Not applicable
VEHICLE STATUS WHEN DTCs ARE OUTPUT	Illuminates check fuel cap warning light (DTC P0457-00: detected). The check fuel cap warning indication is displayed on the multi-information display. (With multi-information display) Illuminates check engine light (after two drive cycle since P0457-00: was detected).
POSSIBLE CAUSE	Missing or loose fuel filler cap Fuel filler cap malfunction PCM malfunction