LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 Turbo Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical System (VIN M)) >> Drive Belt Removal/Installation >> Generator Drive Belt Removal/Installation >> Water Pump Drive Belt >> Removal

Water Pump Drive Belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the generator drive belt. (See Generator Drive Belt Removal/Installation ).
  2. Apply a clean cloth to the water pump drive belt as shown in the figure.
    G13107034Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • To prevent damaging the drive belt, do not stop rotating the crankshaft pulley while performing the removal procedure (with inserted cloth between drive belt and water pump pulley).
  3. Pull the cloth in the direction of the arrow and rotate the crankshaft pulley clockwise.
    G11436539Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The rib of the drive belt can be slid from the groove of the water pump pulley by rotating the crankshaft pulley while pulling the cloth in the direction of the arrow.
  4. Remove the water pump drive belt.
scientia non olet · About LEMON Manuals