Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.

DTC P1728-00: (TCM - FW6AX-EL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	INSPECT ATF LEVEL Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [ FW6AX-EL] ). Is there any malfunction?	Yes	Adjust the ATF level to the specification, then go to the next step. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [ FW6AX-EL] ).
2		No	Replace the automatic transaxle, then go to the next step. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6AX-EL] ).
3	VERIFY DTC TROUBLESHOOTING COMPLETED Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (FW6AX-EL)] ). Perform the following procedure to ensure that the DTC has been resolved: Drive the vehicle without shifting for 20 min or more under the following conditions: Vehicle speed: 5 km/h {3 mph} or more Selector lever position: D position Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (FW6AX-EL)] ). Are any DTCs present?	Yes	ATF amount in Step 2 is correct Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (FW6AX-EL)] ). ATF amount adjusted in Step 2: Replace the automatic transaxle, then drive the vehicle to check it, and if there is no problem then the DTC troubleshooting is complete. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6AX-EL] ).
3		No	DTC troubleshooting completed.