Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

DTC P06B8-00: (TCM - FW6AX-EL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION NOTE: Recording can be facilitated using the screen capture of the PC function. Record the freeze frame data/snap shot data.	-	Go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PERFORM INITIAL LEARNING Perform the initial learning. (See INITIAL LEARNING [ FW6AX-EL] ). Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM ( FW6AX-EL)] ). Perform the following procedure to ensure that the DTC has been resolved: Switch the ignition ON (engine off or on). Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM ( FW6AX-EL)] ). Is the DTC P06B8:00 also present?	Yes	Replace the control valve body, then go to the next step. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [ FW6AX-EL] ).
3		No	DTC troubleshooting completed.
4	VERIFY DTC TROUBLESHOOTING COMPLETED Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM ( FW6AX-EL)] ). Perform the following procedure to ensure that the DTC has been resolved: Switch the ignition ON (engine off or on). Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM ( FW6AX-EL)] ). Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM ( FW6AX-EL)] ).
4		No	DTC troubleshooting completed.