Ignition Coil/Ion Sensor Removal/Installation
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
- Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION ).
- Disconnect the connectors from the ignition coil/ion sensors.
- Remove the ignition coil/ion sensors.
- Install in the reverse order of removal.
Ignition coil/ion sensor installation bolt tightening torque
8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}