LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 Turbo Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Cooling System (VIN M)) >> Coolant Control Valve Removal/Installation >> Lower Radiator Hose Component Installation Note

Lower Radiator Hose Component Installation Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not apply oil (such as engine oil, ATF) to the gasket. Otherwise, the gasket could swell causing a seal malfunction.
  1. Install the lower radiator hose component using the following procedure:
    1. Insert a new gasket into the pipe groove.
    2. Tighten the nuts shown in the figure.
      G12184190Courtesy of MAZDA MOTORS CORP.

      Tightening torque 

      8-10 N.m {82-101 kgf.cm, 71-88 in.lbf}

    3. Secure the lower radiator hose using clips in the order shown in the figure.
    G12184194Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals