Coolant Control Valve Installation Note
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Do not apply oil (such as engine oil, ATF) to the O-ring. Otherwise, the O-ring could swell causing a seal malfunction.
- If the coolant control valve has been replaced, install ECT sensor No. 2. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION ).
- Insert a new gasket into the coolant control valve groove.
- Install the coolant control valve.
Tightening torque
8-10 N.m {82-101 kgf.cm, 71-88 in.lbf}