Brake override system operation inspection

WARNING: This page is about a different variant/trim than selected.

NOTE:

If the brake override system operates normally after performing the following inspection, the PCM detects DTC P2299:00.

Start the engine and let it idle.
Verify that the engine speed becomes less than 1, 200 RPM under the following conditions.
- N position
- Engine speed of 3, 000 RPM or more with accelerator pedal depressed
- Brake pedal depressed
  - If the engine speed becomes approx. 1, 200 RPM, clear the PCM DTC using the M-MDS. (System operation is normal).
  - If the engine speed does not become approx. 1, 200 RPM, inspect for the following parts, then repair or replace the malfunctioning part:
- APP sensor (See ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION ).
- Brake switch No. 1 (See BRAKE SWITCH INSPECTION ).
- Brake switch No. 2 (See BRAKE SWITCH INSPECTION ).
- Communication between PCM and TCM (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [TYPE-A (SKYACTIV-G 2.5)] .) (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [TYPE-B] ).