LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 Turbo Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Fuel System (VIN M)) >> High Pressure Fuel Pump Removal/Installation >> Rear Housing Removal Note

Rear Housing Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the vacuum pump. (See VACUUM PUMP REMOVAL/INSTALLATION ).
  2. Disconnect the hose clips shown in the figure.
    G12184351Courtesy of MAZDA MOTORS CORP.
  3. Remove the bracket shown in the figure.
    G12184352Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the exhaust CMP sensor connector.
  5. Remove the bolts shown in the figure and set the bracket aside so that it does not interfere with the servicing.
    G12184353Courtesy of MAZDA MOTORS CORP.
  6. Remove the rear housing.
scientia non olet · About LEMON Manuals