VIN M, VIN Y
NOTE:
- The fuel gauge sender unit is located in the fuel pump unit. Therefore when replacing the fuel gauge sender unit, refer to "FUEL PUMP UNIT DISASSEMBLY/ASSEMBLY". (See FUEL PUMP UNIT DISASSEMBLY/ASSEMBLY [VIN M] .) (See FUEL PUMP UNIT DISASSEMBLY/ASSEMBLY [VIN Y] ).
- Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION [VIN M] .) (See BEFORE SERVICE PRECAUTION [VIN Y] ).
- If the fuel gauge level indicates 3/4 or more, refer to the "FUEL DRAINING PROCEDURE" and drain the fuel. (See FUEL DRAINING PROCEDURE [VIN M] .) (See FUEL DRAINING PROCEDURE [VIN Y] ).
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
- Remove the rear seat cushion. (See REAR SEAT CUSHION REMOVAL/INSTALLATION ).
- Remove the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION [VIN M] .) (See FUEL PUMP UNIT REMOVAL/INSTALLATION [VIN Y] ).
- Verify that the resistance between fuel pump unit terminals C and D is as indicated in the table.
| Condition of float | Resistance (ohm) |
|---|---|
| Float is at top position | 18.5-21.5 |
| Float is at bottom position | 197-203 |
- If not within the specification, replace the fuel gauge sender unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION [VIN M] .) (See FUEL PUMP UNIT REMOVAL/INSTALLATION [VIN Y] ).