LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Engine Control System (VIN Y) (5 Of 7)) >> DTC P0500-00: VSS Circuit Problem >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0500-00: (PCM, VIN Y) DIAGNOSTIC PROCEDURE

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY STORED DTC IN DSC HU/CM
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [DSC HU/CM] ).
No Go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Always reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC ).
  • Access the RPM and LOAD PIDs using the MMDS. (See ON-BOARD DIAGNOSTIC TEST ).
    CAUTION:
    • While performing this step, always operate the vehicle in a safe and lawful manner.
    • When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later.
  • Drive the vehicle under the following conditions for 14 s.
    • Shift position: except P or N position
    • Absolute load: above 40 %
    • Engine speed: above 2, 000 rpm
      • Brake switch: OFF
  • Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST ).
  • Is the same Pending DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [VIN Y] ).
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals