Function Inspection Using M-MDS
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS
| STEP | INSPECTION | RESULTS | ACTION |
|---|---|---|---|
| 1 | PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY
|
Yes | Perform repair or diagnosis according to the available repair information.
|
| No | Go to the next step. | ||
| 2 | PURPOSE: RECORD FREEZE FRAME DATA/SNAPSHOT DATA AND DIAGNOSTIC MONITORING TEST RESULTS TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
|
- | Go to the next step. |
| 3 | PURPOSE: VERIFY IF DIAGNOSTIC RESULT IS AFFECTED BY MALFUNCTION OF CONTROL PART REQUIRED FOR DIAGNOSIS
|
Yes | Go to the applicable PENDING CODE or DTC inspection. (See DTC P0112-00: ). (See DTC P0113-00: ). (See DTC P0116-00: ). (See DTC P0117-00: ). (See DTC P0118-00: ). (See DTC P0443-00: ). (See DTC P0446-00: ). (See DTC P0451-00: ). (See DTC P0452-00: ). (See DTC P0453-00: ). (See DTC P0460-00: ). (See DTC P0461-00: ). (See DTC P0462-00: ). (See DTC P0463-00: ). (See DTC P2227-00: ). (See DTC P2228-00: ). (See DTC P2229-00: ). |
| No | Go to the Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. |