LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (On-Board Diagnostic - Engine Control System (VIN Y) (4 Of 7)) >> DTC P0442-00, P0455-00, P0456-00: Evaporative Gas Leakage >> PID Item/Simulation Item Used In Diagnosis >> PID/DATA monitor item table

PID/DATA monitor item table

WARNING: This page is about a different variant/trim than selected.
PID/DATA MONITOR PART SPECIFICATION

Item Definition Unit Condition/Specification
BARO Actually measured barometric pressure input from barometric pressure sensor built into PCM KPa {MPA}, mBar {BAR}, psi, in H20
  • Displays BARO
EVAPCP Purge solenoid valve control duty value %
  • Idle (after warm up): 0% (Engine coolant temperature 59 °C {140 °F} or less)
  • Racing (Engine speed 2, 000 rpm): 33-35% (ECT is 94 °C {201 °F})
  • Racing (Engine speed 4, 000 rpm): 53-55% (ECT is 94 °C {201 °F})
EVAPCV CV solenoid valve operation status Off/On
  • Simulation item (EVAPCV) is ON: On
FCL Check fuel cap warning indication display condition/check fuel cap warning light illumination condition Off/On
  • Check fuel cap warning indication displayed/check fuel cap warning light turned on: On
  • Check fuel cap warning indication not displayed/check fuel cap warning light turned off: Off
FTP Fuel tank pressure Pa {KPA}, mBar {BAR}, psi, in H20
  • Displays fuel tank pressure
Fuel tank pressure sensor voltage V
  • Fuel tank pressure is equal to barometric pressure: Approx. 2.6 V
scientia non olet · About LEMON Manuals