Rear Oil Seal Replacement: Notes

WARNING: This page is about a different variant/trim than selected.

Special Service Tool (SST)

49 S033 101
Dust cover installer

Courtesy of MAZDA MOTORS CORP.

Replacement Part

Rear oil seal

Quantity: 1

Location of use: Cylinder block

Oil and Chemical Type

Engine oil

Type: Recommended oil

Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] (AWD)).
Remove the drive plate. (See DRIVE PLATE REMOVAL/INSTALLATION [GW6A-EL, GW6AX-EL] ).

Remove in the order indicated in the table. 4. Install in the reverse order of removal.

Courtesy of MAZDA MOTORS CORP.

PART SPECIFICATION

1	Rear oil seal (See Rear Oil Seal Removal Note ). (See Rear Oil Seal Installation Note ).