LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical System (VIN Y)) >> Oil Control Valve (OCV) Removal/Installation

Oil Control Valve (OCV) Removal/Installation

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION ).
  3. Remove the ignition coil/ion sensors. (See IGNITION COIL/ION SENSOR REMOVAL/INSTALLATION ).
  4. Remove the cylinder head cover. (See TIMING CHAIN REMOVAL/INSTALLATION ).
  5. Remove in the order indicated in the table. 6. Install in the reverse order of removal.
    Fig 1: Oil Control Valve Components With Torque Specification
    G13671782Courtesy of MAZDA MOTORS CORP.
    PART SPECIFICATION

    1 OCV installation bolt
    2 OCV
scientia non olet · About LEMON Manuals