Idle Speed Inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The idle speed cannot be adjusted.
- The M-MDS is required to verify the idle speed.
- Complete the engine tune-up preparation. (See Engine Tune-up Preparation ).
- Verify that the idle speed (M-MDS PID: RPM) is within the specification using the PID/data monitor function of the M-MDS. (See PCM INSPECTION
).
- If there is a malfunction, refer to "ENGINE SYMPTOM TROUBLESHOOTING". (See SYMPTOM DIAGNOSTIC INDEX ).
Idle speed (P position or N position)
650-750 rpm