DTC P0096-00: IAT Sensor No. 2 Circuit Range/Performance Problem: Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0096-00: (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0096-00: |
IAT sensor No. 2 circuit range/performance problem |
| DETECTION CONDITION |
- Any one of the following conditions is met:
- The condition has continued for 2 s in which difference in intake air temperature measured by the IAT sensor No. 2 and IAT sensor No. 1 is 17 °C {31 °F} or more or -26 °C {-47 °F} or less.
- The condition has continued for 2 s in which difference in intake air temperature measured by the boost air temperature sensor and IAT sensor No. 2 is 17 °C {31 °F} or more or -26 °C {-47 °F} or less.
MONITORING CONDITIONS
- Period vehicle being left: 6 h or more
- Battery voltage: 8 V or more
- Within 20 s after engine start
- The following DTCs are not detected:
- Boost air temperature sensor: P007C-00: and P007D-00:
- IAT sensor No. 1: P0112-00:, P0113-00:
- IAT sensor No. 2: P0097-00: and P0098-00:
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- MAP sensor/IAT sensor No. 2 connector or terminals malfunction
- IAT sensor No. 2 malfunction
- PCM connector or terminals malfunction
- PCM malfunction
|
| SYSTEM WIRING DIAGRAM |
|