Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

SLOW ENGAGING AFTER OPERATING SELECTOR LEVER FROM N TO D POSITION (GW6AX-EL) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY MALFUNCTION SYMPTOM Is the malfunction symptom at the same level compared to a vehicle of the same model (GW6A-EL, GW6AX-EL vehicles)?	Yes	Complete the symptom troubleshooting.
1		No	Go to the next step.
2	VERIFY DTCs Are any DTCs detected?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL, GW6AX-EL)] ).
2	VERIFY DTCs Are any DTCs detected?	No	Go to the next step.
3	PERFORM INITIAL LEARNING AND N TO D RANGE LEARNING Perform the initial learning. (See INITIAL LEARNING [GW6AX-EL] ). Perform the N to D position learning using the following procedure: Set the ATF temperature to 30 °C {86 °F} or more. Shift the selector lever to N position. Shift the selector lever to D position and wait for 5 s or more. Shift the selector lever to N position and wait for 5 s or more. Perform steps (3) to (4) 10 times. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting.
3		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] ).