Diagnostic procedure
WARNING: This page is about a different variant/trim than selected.
NO CREEP AT ALL (GW6AX-EL) DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | INSPECT ENGINE CONTROL SYSTEM FOR MALFUNCTION
|
Yes | Repair or replace any malfunctioning parts according to the inspection result. |
| No | Go to the next step. | ||
| 2 | VERIFY IF MALFUNCTION CAUSE IS TORQUE CONVERTER
|
Yes | Symptom troubleshooting is completed. |
| No | Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] ). |