Diagnostic procedure
WARNING: This page is about a different variant/trim than selected.
FREQUENT SHIFTING (GW6AX-EL) DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | INSPECT SIGNAL PARTS FOR MALFUNCTION
|
Yes | Repair or replace any malfunctioning parts according to the inspection result. |
| No | Go to the next step. | ||
| 2 | VERIFY IF MALFUNCTION CAUSE LOW-G (XY) SENSOR
|
Yes | Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] ). |
| No | Symptom troubleshooting is completed. |