LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (On-Board Diagnostics - A/T (GW6AX-El)) >> DTC P0715-00: Turbine/Input Shaft Speed Sensor/Sensor Output Range Malfunction >> Notes

DTC P0715-00: Turbine/Input Shaft Speed Sensor/Sensor Output Range Malfunction: Notes

WARNING: This page is about a different variant/trim than selected.
DTC P0715-00: (TCM - GW6AX-EL) DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0715:00 Turbine/input shaft speed sensor/sensor output range malfunction
DETECTION CONDITION
  • Under the following conditions, the difference between engine speed signal and turbine/input shaft speed signal is 400 rpm or more for 1 s:
  • Engine is running.
  • Turbine/input shaft speed sensor is 9, 000 rpm or less.
    • The gear shift position is in the neutral condition.
FAIL-SAFE FUNCTION
  • Set to TCC control.
  • Inhibits learning control.
  • Inhibits manual mode.
  • Inhibits neutral idle control.
  • Inhibits AAS.
  • Inhibits 5GR and 6GR.
  • Inhibits shift down when the accelerator pedal is depressed.
POSSIBLE CAUSE
  • Turbine/input shaft speed sensor malfunction
SYSTEM WIRING DIAGRAM Not applicable
scientia non olet · About LEMON Manuals