LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (On-Board Diagnostics - A/T (GW6AX-El)) >> DTC P0218-00: Automatic Transaxle Protection Control >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0218-00: (TCM - GW6AX-EL) DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture of the PC function.
  • Record the freeze frame data/snap shot data.
- Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT ATF LEVEL
Yes Adjust the ATF level to the specification, then go to Step 5.
(See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [ GW6AX-EL] ).
No Go to the next step.
4 INSPECT OIL COOLER
  • Visually inspect the oil cooler.
  • Is there any malfunction?
Yes Replace the oil cooler, then go to the next step.
(See OIL COOLER REMOVAL/INSTALLATION [ GW6AX-EL (VIN M)] ).
No Go to the next step.
5 VERIFY DTC TROUBLESHOOTING COMPLETED Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6AX-EL)] ).
No DTC troubleshooting completed.