LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (On-Board Diagnostic - Engine Control System (VIN Y) (3 Of 7)) >> DTC P0236-00: Boost Pressure Sensor Circuit Range/Performance Problem >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0236-00: (PCM, VIN Y) DIAGNOSTIC PROCEDURE

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT BOOST PRESSURE SENSOR/BOOST AIR TEMPERATURE SENSOR CONNECTOR CONDITION
  • Switch the ignition off.
  • Disconnect the boost pressure sensor/boost air temperature sensor connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the connector and/or terminals, then go to Step 6.
No Go to the next step.
4 INSPECT BOOST PRESSURE SENSOR
 Yes Replace the boost pressure sensor/boost air temperature sensor, then go to Step 6.
(See BOOST PRESSURE SENSOR/BOOST AIR TEMPERATURE SENSOR REMOVAL/INSTALLATION [VIN Y] ).
No Go to the next step.
5 INSPECT PCM CONNECTOR CONDITION
  • Disconnect the PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the connector and/or terminals, then go to the next step.
No Go to the next step.
6 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Always reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC ).
  • Start the engine. (Engine cold)
  • Drive the vehicle on a flat road surface 10 times under the following conditions.
  1. Drive the vehicle in second gear at 25 km/h {16 mph} while maintaining the speed for 25 s.
  2. Stop the vehicle and idle the engine.
 Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals