LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (On-Board Diagnostic - Engine Control System (VIN Y) (3 Of 7)) >> DTC P0234-00: Dynamic Pressure Turbo (Dpt) OVERBOOST Condition >> PID Item/Simulation Item Used In Diagnosis >> PID/DATA monitor item table

PID/DATA monitor item table

WARNING: This page is about a different variant/trim than selected.
PID/DATA MONITOR PART SPECIFICATION

Item Definition Unit Condition/Specification
MAP Manifold absolute pressure input from MAP sensor KPa {MPA}, mBar {BAR}, psi, in H20
  • Displays MAP
MAP_V MAP sensor voltage V
  • Ignition switched ON (engine off) (no load) (MAP: 102 kPa {1.04 kgf/cm 2 , 14.8 psi}): Approx. 1.75 V
  • Idle (after warm up) (no load) (MAP: 30 kPa {0.31 kgf/cm 2 , 4.4 psi}): Approx. 0.68 V
  • Racing (engine speed is 2, 000 rpm) (no load) (MAP: 27 kPa {0.28 kgf/cm 2 , 3.9 psi}): Approx. 0.61 V
scientia non olet · About LEMON Manuals