Water Pump Component Installation Note

1. Tighten the bolts in the order shown in the figure.
   Fig 1: Water Pump Components Bolts Tightening Sequence

   Courtesy of MAZDA MOTORS CORP.

   Tightening torque 

   20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}

2. Install the engine oil temperature sensor/engine oil pressure sensor. (See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION ).
3. Install the wiring harness clip shown in the figure.

   Courtesy of MAZDA MOTORS CORP.

4. Tighten the bolt shown in the figure.

Courtesy of MAZDA MOTORS CORP.

Tightening torque 

8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}