Except U.S.A. and CANADA: Notes

WARNING: This page is about a different variant/trim than selected.

Level the vehicle.
Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION ).
Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
Drain the fuel. (See FUEL DRAINING PROCEDURE ).
Remove the rear seat cushion. (See REAR SEAT CUSHION REMOVAL/INSTALLATION ).
Remove the service hole cover.

Courtesy of MAZDA MOTORS CORP.
Disconnect the following parts:
- Fuel pump unit connector
- Quick release connector (See QUICK RELEASE CONNECTOR (FUEL SYSTEM) REMOVAL/INSTALLATION ).
Remove the floor under cover. (See FLOOR UNDER COVER REMOVAL/INSTALLATION ).
Disconnect the HO2S connector. (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION ).
Remove the HO2S clip from the body. (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION ).
Remove the TWC and HO2S as a single unit. (See EXHAUST SYSTEM REMOVAL/INSTALLATION ).
Remove in the order indicated in the table.
Install in the reverse order of removal.
Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION ).

Fig 1: Fuel Tank Components With Torque Specification (Except U.S.A. And Canada)

Courtesy of MAZDA MOTORS CORP.

PART SPECIFICATION

1	Joint hose (See Joint hose installation note ).
2	Fuel tank strap
3	Breather hose (See Breather hose installation note ).
4	Evaporative hose (See Evaporative hose installation note ).
5	Fuel pump unit (See FUEL PUMP UNIT REMOVAL/INSTALLATION ).
6	Fuel tank (See Fuel tank removal note ).
7	Fuel tank insulator (See Fuel tank insulator removal note ).