Rear Ultrasonic Sensor Short-Cord Inspection

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
2. Remove the following parts:
   1. Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION ).
   2. Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION ).
   3. Rear ultrasonic sensor short-cord (See REAR ULTRASONIC SENSOR SHORT-CORD REMOVAL/INSTALLATION ).
3. Verify that the continuity between the rear ultrasonic sensor short-cord terminals is as indicated in the table.

Courtesy of MAZDA MOTORS CORP.

Courtesy of MAZDA MOTORS CORP.

• If not as indicated in the table, replace the rear ultrasonic sensor short-cord. (See REAR ULTRASONIC SENSOR SHORT-CORD REMOVAL/INSTALLATION ).