Rear Parking Sensor Buzzer Inspection

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
2. Remove the following parts:
   1. Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION ).
   2. Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION ).
   3. Liftgate recess cover (See LIFTGATE RECESS REMOVAL/INSTALLATION ).
   4. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION ).
   5. Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION ).
   6. Rear parking sensor buzzer (See REAR PARKING SENSOR BUZZER REMOVAL/INSTALLATION ).
3. Verify the continuity between rear parking sensor buzzer terminals A and B.

Courtesy of MAZDA MOTORS CORP.

Courtesy of MAZDA MOTORS CORP.

• If not as indicated in the table, replace the parking sensor buzzer. (See REAR PARKING SENSOR BUZZER REMOVAL/INSTALLATION ).