Diagnostic Procedure
DTC U2005:86 (INSTRUMENT CLUSTER) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY PCM DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (VIN Y)] ). (See DTC TABLE [PCM (VIN M)] ). |
| No | Go to the next step. | ||
| 2 | VERIFY IF MALFUNCTIONING LOCATION IS PCM DEPENDING ON REPEATABILITY
|
Yes | Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [VIN Y] ). (See PCM REMOVAL/INSTALLATION [VIN M] ). |
| No | Go to Step 4. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION ). |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] ). |
| No | DTC troubleshooting completed. | ||