Using the M-MDS
- Connect the M-MDS to the DLC-2.
- After vehicle identification, select the following items from the initialization screen of the M-MDS.
- "Toolbox" (2)"Diagnosis" (3)"Data Logger" (4)"IC"
- Using the simulation function SPD_MTR, verify that the values are as indicated in the table.
TACHOMETER DISPLAY SPECIFICATION
| M-MDS display | Tachometer display |
|---|---|
| 0% | Tachometer needle moves to bottommost position. |
| 20% | Tachometer needle moves to approx. 60 km/h {37.3 mph}. |
| 40% | Tachometer needle moves to approx. 120 km/h {74.6 mph}. |
- If not as indicated in the table, inspect the related wiring harnesses.
- If the related wiring harnesses are normal, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)