LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-9 Touring, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> On-Board Diagnostic - Instrument Cluster >> PID/Data Monitor Table [Instrument Cluster]

PID/Data Monitor Table [Instrument Cluster]

-: Not applicable

PID Unit/Operation Data contents Module control terminal
AFS_ST (6) Off/On
  • Off: Adaptive front lighting system (AFS) is not operated
  • On: Adaptive front lighting system (AFS) is operated
 -
AT_MAN_M_SW Off/On/Reserved/Unknown
  • Off: Selector lever is not in M position.
  • On: Selector lever is in M position.
  • Reserved: -
  • Unknown: M position switch signal is not determined.
 1H
AT_S_DWN_SW Off/On/Reserved/Unknown
  • Off: Selector lever is not in shift-down position (-).
  • On: Selector lever is in shift down position (-).
  • Reserved: -
  • Unknown: Down switch signal is not determined.
 1G
AT_S_UP_SW Off/On/Reserved/Unknown
  • Off: Selector lever is not in shift up position (+).
  • On: Selector lever is in shift up position (+).
  • Reserved: -
  • Unknown: Up switch signal is not determined.
 1F
BSM/RVM_SW (1) Off/On
  • Off: Blind spot monitoring (BSM) OFF switch is off.
  • On: Blind spot monitoring (BSM) OFF switch is on.
 1V
DIM_CSW (2) Off/On
  • Off: Dimmer cancel switch is off.
  • On: Dimmer cancel switch is on.
 -
DSC_OFF_SW Off/On
  • Off: TCS OFF switch (without OFF-road Traction Assist)/OFF-road Traction Assist switch (with OFF-road Traction Assist) is off.
  • On: TCS OFF switch (without OFF-road Traction Assist)/OFF-road Traction Assist switch (with OFF-road Traction Assist) is on.
 1V
FUEL_GAUGE(3) L Displays fuel level detected by the fuel gauge. -
FUEL_SEN_M ohm Displays fuel gauge sender unit resistance value. -
V
NOTE:
  • Displays in the M-MDS but it does not operate.
FUEL_SEN_S (4) ohm Displays fuel gauge sender unit (sub) resistance value. -
V
NOTE:
  • Displays in the M-MDS but it does not operate.
I_ILLUMI_M Off (Day)/On (Night)
  • Off (Day): TNS (parking lights) switch is off.
  • On (Night): TNS (parking lights) switch is on.
  • 1B
  • 1D
I-ST_OFF_SW Off/On
NOTE:
  • Displays in the M-MDS but it does not operate.
LDWS_ON_SW Off/On
  • Off: LDWS OFF switch is on.
  • On: LDWS OFF switch is off.
 1V
MULTI_SW_ST O.K./FAULT
  • O.K.: Cluster switch is normal.
  • FAULT: Cluster switch is malfunctioning.
 1V
ODO_CNT km, ft, mi Displays rolling count of the odometer -
P_BRAKE_SW Off/On
  • Off: Electric parking brake switch is pressed.
  • On: Electric parking brake switch is pulled up.
 1L
PCONSW (2) % Displays the brightness of the illumination lights -
R_GEAR_SW Off/On
NOTE:
  • Displays in the M-MDS but it does not operate.
R_LMP Off/On/Unknown/Fault
  • Off: Selector lever is not in R position
  • On: Selector lever is in R position
  • Unknown: Back-up light signal is not determined.
  • Fault: Back-up light malfunction
  • 1B
  • 1D
SPEEDOMTR KPH, MPH Displays vehicle speed -
TACHOMTR RPM Displays engine speed -
TM_CLPOS (2) 2Positions/P/R/N/D/S (2)/L (1)/- Displays the selector lever position
  • 1B
  • 1D
TOTAL_TIME hh:mm:ss Displays cumulative elapsed time since vehicle completion -
TPMS_CAL_SW Off/On
  • Off: Tire pressure monitoring system (TPMS) set switch is off.
  • On: Tire pressure monitoring system (TPMS) set switch is on.
 1V
TPRE_LMOD Normal/Error This PID indicates supply voltage (wheel unit No. 4). -
VPWR V Displays power supply voltage
  • 1S
  • 1U
WU1_ERR_P Normal/Error This PID indicates tire pressure status (wheel unit No. 1). -
WU1_ERR_T Normal/Error This PID indicates tire air temperature status (wheel unit No. 1). -
WU1_ID (5) HexData This PID indicates registered wheel unit ID (wheel unit No. 1). -
WU1_P (5) KPa, MPa This PID indicates tire pressure (wheel unit No. 1). -
WU1_T (5) °C, F This PID indicates tire air temperature (wheel unit No. 1). -
WU1_VPWR (5) Normal/Error This PID indicates supply voltage (wheel unit No. 1). -
WU2_ERR_P Normal/Error This PID indicates tire pressure status (wheel unit No. 2). -
WU2_ERR_T Normal/Error This PID indicates tire air temperature status (wheel unit No. 2). -
WU2_ID (5) HexData This PID indicates registered wheel unit ID (wheel unit No. 2). -
WU2_P (5) KPa, MPa This PID indicates tire pressure (wheel unit No. 2). -
WU2_T (5) °C, F This PID indicates tire air temperature (wheel unit No. 2). -
WU2_VPWR (5) Normal/Error This PID indicates supply voltage (wheel unit No. 2). -
WU3_ERR_P Normal/Error This PID indicates tire pressure status (wheel unit No. 3). -
WU3_ERR_T Normal/Error This PID indicates tire air temperature status (wheel unit No. 3). -
WU3_ID (5) HexData This PID indicates registered wheel unit ID (wheel unit No. 3). -
WU3_P (5) KPa, MPa This PID indicates tire pressure (wheel unit No. 3). -
WU3_T (5) °C, F This PID indicates tire air temperature (wheel unit No. 3). -
WU3_VPWR (5) Normal/Error This PID indicates supply voltage (wheel unit No. 3). -
WU4_ERR_P Normal/Error This PID indicates tire pressure status (wheel unit No. 4). -
WU4_ERR_T (5) Normal/Error This PID indicates tire air temperature status (wheel unit No. 4). -
WU4_ID (5) HexData This PID indicates registered wheel unit ID (wheel unit No. 4). -
WU4_P (5) KPa, MPa This PID indicates tire pressure (wheel unit No. 4). -
WU4_T (5) °C, F This PID indicates tire air temperature (wheel unit No. 4). -
WU4_VPWR (5) Normal/Error This PID indicates supply voltage (wheel unit No. 4). -
(1) With blind spot monitoring (BSM) system
(2) If equipped
(3) With instrument cluster (Type B or C)
(4) AWD

*5: With lane departure warning system (LDWS)
(5) With tire pressure monitoring system (TPMS)
(6) With adaptive front lighting system (AFS)
scientia non olet · About LEMON Manuals