LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-9 Touring, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> On-Board Diagnostic - Active Driving Display >> DTC Inspection [Active Driving Display] >> Snapshot Data

Snapshot Data

-: Not applicable

SNAPSHOT DATA ITEM DESCRIPTION

Snapshot data item Unit Data contents Data read/use method Corresponding data monitor items
AAT °C °F Ambient temperature - -
APP_STATUS Accelerator Pedal Off/Under20%/Over20%/FAIL Accelerator pedal position status - -
CFG_STATUS Config Complete/Not Configured/Config Error Instrument cluster configuration status - -
ECT_STATUS Under 0 degrees C/0 - Under 80 degrees C/Over 80 degrees C/FAIL Engine coolant temperature status - -
IC_VPWR V Instrument cluster power supply voltage When DTC is detected, instrument cluster displays power supply voltage value of instrument cluster in M-MDS. VPWR
IG-ON_TIMER hh:mm:ss (1) Elapsed time since ignition was switched ON (engine off or on)
NOTE:
  • The instrument cluster records the elapsed time since the ignition was switched ON (engine off or on).
 When DTC is detected, instrument cluster displays elapsed time since ignition was switched ON (engine off or on) in M-MDS. -
PWR_MODE_KEY Key Out/Key Recently Out (Position 0)/Accessory (Position 1)/Post Ignition (Position 2)/Ignition On (Position 2)/Running (Position 2)/Running - Starting
  • Key Out: Ignition switched off
  • Key Recently Out (Position 0): Elapsed time within 3 s since ignition was switched off
  • Accessory (Position 1): Ignition is switched to ACC
  • Post Ignition (Position 2): Elapsed time within 3 s since ignition was switched ON (engine off or on)
  • Ignition On (Position 2): Ignition switched ON (engine off)
  • Running (Position 2): Ignition switched ON (engine on)
  • Running - Starting: Cranking condition
 When DTC is detected, instrument cluster displays ignition switch status in MMDS. -
RPM_STATUS Engine Stop/Under1500rpm/Over1500rpm/F AIL Engine speed status When DTC is detected, instrument cluster displays engine speed in MMDS. TACHOMTR
SHIFT_STATUS P/N/D/R/FAIL Selector lever position status When DTC is detected, instrument cluster displays selector lever position in M-MDS. -
TOTAL_DIST km Miles Accumulate d total traveled distance from completion of vehicle until instrument cluster detects DTC (Odometer value in instrument cluster) The total traveled distance from which the instrument cluster detects DTCs to the present can be calculated by performing the following procedure.
  1. Verify the odometer value in the instrument cluster.
  2. Verify the snapshot data item TOTAL_DIST.
  3. Subtract 2 from 1.
 -
TOTAL_TIME hh:mm:ss (1) Accumulated total elapsed time since vehicle completion until instrument cluster detects a DTC
NOTE:
  • When the ROOM fuse is removed, and the ignition is switched off, the time is not included in the elapsed time.
 The elapsed time from which the instrument cluster detects DTCs to the present can be calculated by performing the following procedure.
  1. Verify the instrument cluster PID item TOTAL_TIME.
  2. Verify the snapshot data item TOTAL_TIME.
  3. Subtract 2 from 1.
 TOTAL_TIME
VPWR V Instrument cluster power supply voltage - VPWR
VSPD_STATUS Stop/0-10km/h/Over10km/h/FAIL Vehicle speed status When DTC is detected, instrument cluster displays vehicle speed in MMDS. SPEEDOMTR
(1) The seconds may be indicated after the decimal point.
scientia non olet · About LEMON Manuals