LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-9 Sport, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Trunk Side Trim Removal/Installation

Trunk Side Trim Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    2. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    3. Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    5. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    6. Third-row seat cushion (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION .)
    7. Third-row seat back component (See THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION .)
  3. Partially peel back the seaming welt.
    G11435038Courtesy of MAZDA MOTORS CORP.
  4. Slide the second-row seat forward.
  5. Partially peel back the weather strip.
    G11435039Courtesy of MAZDA MOTORS CORP.
  6. Remove the fastener.
    G11435040Courtesy of MAZDA MOTORS CORP.
  7. Remove the service hole covers.
    G11435041Courtesy of MAZDA MOTORS CORP.
  8. Remove the screws.
    G11435042Courtesy of MAZDA MOTORS CORP.
  9. Affix protective tape to the position shown in the figure.
    G11435043Courtesy of MAZDA MOTORS CORP.
  10. Using the remover tool, remove the trunk side tray in the direction of arrow shown in the figure while detaching the clip A, clips B.
    G11435044Courtesy of MAZDA MOTORS CORP.
  11. Pull the cover in the direction the of arrow shown in the figure.
    Fig 1: Cargo Net Hook Bolt With Torque Specification
    G11435045Courtesy of MAZDA MOTORS CORP.
  12. Remove the bolts, then remove the cargo net hooks.
  13. Remove the bolt, then remove the cargo net hook.
    Fig 2: Cargo Net Hook Bolt With Torque Specification
    G11435046Courtesy of MAZDA MOTORS CORP.
  14. Pull the trunk side trim in the direction of the arrows sin the order of (1), (2), (3), (4), (5) and remove it while detaching the clips, hooks.
    G11435047Courtesy of MAZDA MOTORS CORP.
  15. Disconnect the accessory socket connector. (RH only)
  16. Disconnect the rear side speaker connector. (with rear side speaker)
  17. Disconnect the USB power outlet connector. (with USB power outlet)
  18. Remove the trunk side trim.
  19. When removing the trunk insulator, perform the following procedure:
    1. Remove the fastener.
      G12266536Courtesy of MAZDA MOTORS CORP.
    2. Rotate the cap nut in the direction of the arrow and remove it from the stud bolt.
      G12266537Courtesy of MAZDA MOTORS CORP.
    3. Remove the trunk insulator.
  20. Install in the reverse order of removal.
    NOTE:
scientia non olet · About LEMON Manuals