LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Automatic Transaxle (GW6A-El, GW6AX-El)) >> DTC U0074-00: Can System Communication Error (Local Can Between TCM And Pcm) >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC U0074:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 VERIFY PCM DTC Yes DTC U0074:00 is displayed:
  • CAN communication line can be considered the cause.
    • Refer to the wiring diagram and verify whether or not there is a common connector between TCM and PCM.

If there is a common connector:
  • Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a malfunction.
  • Repair or replace the malfunctioning part.

If there is no common connector:
  • Repair or replace the wiring harness.
  • Go to the next step.

DTC other than U0074:00 is displayed:
No Go to the next step.
3 VERIFY DTC TROUBLESHOOTING COMPLETED Yes Replace the control valve body, then go to the next step.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [GW6A-EL, GW6AX-EL] .)
No Go to the next step.
4 VERIFY NO DTC IS PRESENT
  • Are any DTCs present?
 Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals