LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Automatic Transaxle (GW6A-El, GW6AX-El)) >> DTC P2855-00: Low Clutch Hydraulic Circuit/Sealing Malfunction >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC P2855:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INSPECT ATF LEVEL Yes Adjust the ATF level to the specification, then go to the next step.
(See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [GW6A-EL, GW6AX-EL] .)
No Replace the automatic transaxle.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL (VIN Y)] .)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] .)
2 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Verify that the ATF temperature is 30 °C {86 °F} or more.
    2. Perform the following operation 20 times.
      • Operate the selector lever from N to D position and wait for 5 s or more.
      • Operate the selector lever from D to N position and wait for 5 s or more.
  • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Is the DTC P2855:00 also present?
 Yes Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL (VIN Y)] .)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals