LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Automatic Transaxle (GW6A-El, GW6AX-El)) >> DTC P1728-00: Clutch Slippage >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC P1728:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 INSPECT ATF LEVEL Yes Adjust the ATF level to the specification, then go to the next step.
(See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [GW6A-EL, GW6AX-EL] .)
No Replace the automatic transaxle, then go to the next step.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL (VIN Y)] .)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] .)
3 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Drive the vehicle without shifting for 20 min or more under the following conditions:
  • Vehicle speed: 5 km/h {3 mph} or more
  • Selector lever position: D position
  • Perform the DTC inspection using the M-MDS.

    (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)

  • Are any DTCs present?
 Yes ATF amount in Step 2 is correct

ATF amount adjusted in Step 2:
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals