LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Automatic Transaxle (GW6A-El, GW6AX-El)) >> DTC P0667-00: Ecu Internal Temperature Sensor/Performance Problem >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0667:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture of the PC function.
  • Record the freeze frame data/snap shot data.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.

Go to the next step.
No Replace the control valve body, then go to the next step.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [GW6A-EL, GW6AX-EL] .)
3 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Soak for 6 hours or more.
    2. Start the engine, and warm it up until the ATF temperature is 60 °C {140 °F} or more, and the engine coolant temperature is 80 °C {176 °F} or more.
  • Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Are any DTCs present?
 Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals