LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (On-Board Diagnostic - Automatic Transaxle (GW6A-El, GW6AX-El)) >> DTC P0500-00: Vehicle Speed Signal Circuit Malfunction >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0500:00 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture of the PC function.
  • Record the freeze frame data/snap shot data.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY STORED DTC IN DSC HU/Control Module
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [DSC HU/CM] .)
No Go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Drive the vehicle for 10 s or more under the following conditions:
  • Battery voltage: 8 V or more
  • Vehicle speed: 45 km/h {28 mph} or more
  • Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .)
  • Are any DTCs present?
 Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals