LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostic - Engine Control (VIN Y) (3 Of 3)) >> DTC P2610-00: Malfunction In Instrument Cluster >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P2610:00 (PCM, VIN Y) DIAGNOSTIC PROCEDURE

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY STORED DTC IN INSTRUMENT CLUSTER Yes Go to the applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER] .)
No Go to the next step.
4 INSPECT INSTRUMENT CLUSTER BACKUP VOLTAGE CIRCUIT
  • Switch the ignition off.
  • Remove the MAIN 200 A fuse, ROOM 25 A fuse and INTERIOR1 15 A fuse.
  • Inspect the MAIN 200 A fuse, ROOM 25 A fuse and INTERIOR1 15 A fuse.
  • Is there any malfunction?
 Yes Replace the malfunctioning fuse.
Switch the ignition ON (engine on) and wait for 10 s or more.
Switch the ignition off.
Go to the next step.
No Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
5 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Always reconnect all disconnected connectors.
NOTE:
  • DTC P2610:00 can be cleared by performing the engine start and stop procedure.
  • Start the engine.
  • Stop the engine.
  • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .)
  • Perform the KOER self test. (See KOEO/KOER SELF TEST .)
  • Is the same Pending DTC present?
 Yes Repeat the inspection from Step 1.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals