Details On DTCs

WARNING: This page is about a different variant/trim than selected.

DTC P250F:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

DESCRIPTION	Engine oil level signal: engine oil level low
DETECTION CONDITION	Determination conditions	The engine oil level has decreased around or below MIN mark.
	Preconditions	Engine speed: 750-2, 000 rpm Vehicle speed: 5 km/h {3 mph} or more Engine oil control: during low oil pressure Engine oil temperature: 20-90 °C {68-194°F} G at front and back of vehicle: 0.2 G or less G at left and right sides of vehicle: 0.2 G or less The following DTC is not detected: Communication error between engine oil level sensor and PCM: U1100:00 Engine oil level sensor power supply circuit: P250A:00, P250C:00
	Drive cycle	1
	Self test type	CMDTC self test
	Sensor used	PCM Engine oil level sensor Engine oil temperature sensor Low-G (XY) sensor (built-into SAS control module)
FAIL-SAFE FUNCTION	Not applicable
VEHICLE STATUS WHEN DTCs ARE OUTPUT	Illuminates engine oil level warning light. The engine oil level warning indication is displayed on the multi-information display. (With multi-information display)
POSSIBLE CAUSE	Improper engine oil level (low) Engine oil leakage PCM malfunction