LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostic - Engine Control (VIN Y) (3 Of 3)) >> DTC P2228-00: BARO Sensor Circuit Low Input >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P2228:00 (PCM, VIN Y) DIAGNOSTIC PROCEDURE

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT BARO SENSOR Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [VIN Y] .)
No Go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .)
  • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST .)
  • Is the same Pending DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [VIN Y] .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE Yes Go to the applicable DTC inspection. (See DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals