LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostic - Engine Control (VIN Y) (3 Of 3)) >> DTC P144A-00: Evaporator System: Clogging Between Fuel Tank And Fuel Tank Pressure Sensor >> PID Item/Simulation Item Used In Diagnosis >> Simulation item table

Simulation item table

WARNING: This page is about a different variant/trim than selected.
SIMULATION PART DESCRIPTION

Item Applicable component Unit/Condition Engine condition Other condition
EVAPCP Purge solenoid valve %
  • Under the following conditions:
    • Ignition is switched ON (engine off)
    • Idle
    • Racing (not idle)
  • Under the following conditions:
    • Override drive parameter

      input range: 0-100%
EVAPCV CV solenoid valve Off/On
  • Under the following conditions:
    • Ignition is switched ON (engine off)
    • Idle
    • Racing (not idle)
CAUTION:
  • Do not add fuel with the CV solenoid valve closed. Otherwise, it will result in air pollution because the evaporative gas in the fuel tank will escape directly into the atmosphere.
NOTE:
  • Override drive parameter: Off
    • CV solenoid valve: open
  • Override drive parameter: On
    • CV solenoid valve: close
scientia non olet · About LEMON Manuals