Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

DTC P130C:00 (PCM, VIN Y) DIAGNOSTIC PROCEDURE

STEP	INSPECTION	RESULTS	ACTION
1	RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION NOTE: Recording can be facilitated using the screen capture function of the PC. Record the FREEZE FRAME DATA/snapshot data on the repair order.	-	Go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY RELATED PENDING CODE AND/OR DTC Switch the ignition off, then ON (engine off). Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Are any other PENDING CODEs and/or DTCs present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC TABLE .)
3		No	Go to the next step.
4	VERIFY IF MALFUNCTION CAUSED BY ABNORMAL FUEL Switch the ignition off. Drain the fuel and add the specified fuel. (See FUEL DRAINING PROCEDURE [VIN Y] .)	-	Go to the next step.
5	VERIFY IF MALFUNCTION CAUSE WAS CORRECTED BY REFUELING Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .) Perform the following: Start the engine and warm it up completely. Wait for 1 min (idle). Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Is the PENDING CODE for this DTC present?	Yes	NOTE: A malfunction has occurred because carbon has accumulated in combustion chamber. Overhaul the engine and remove the carbon in the combustion chamber.Go to the next step.
5		No	Go to Step 7.
6	VERIFY DTC TROUBLESHOOTING COMPLETED Always reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .) Perform the following: Start the engine and warm it up completely. Wait for 1 min (idle). Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [VIN Y] .) Go to the next step.
6		No	Go to the next step.
7	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
7		No	DTC troubleshooting completed.