Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

NO CREEP AT ALL (GW6A-EL, GW6AX-EL) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT ENGINE CONTROL SYSTEM FOR MALFUNCTION Perform the symptom troubleshooting "LOW IDLE/STALLS DURING DECELERATION". (See NO. 10 LOW IDLE/STALLS DURING DECELERATION [VIN Y] .) Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
1		No	Go to the next step.
2	VERIFY IF MALFUNCTION CAUSE IS TORQUE CONVERTER Is the malfunction symptom at same level compared to a vehicle of the same model?	Yes	Symptom troubleshooting is completed.
2		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL (VIN Y)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] .)