LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Engine Starting System (VIN Y)) >> Starter Removal/Installation >> Terminal B Cable Disconnection Note

Terminal B Cable Disconnection Note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the two bolts shown in the figure.
    Fig 1: Wiring Harness Bracket Bolts With Torque Specification
    G11433356Courtesy of MAZDA MOTORS CORP.
  2. Set aside the wiring harness and wiring harness bracket as a single unit.
  3. Disconnect the terminal B cable.
scientia non olet · About LEMON Manuals