Transfer Oil Seal (RH) No. 2
WARNING: This page is about a different variant/trim than selected.
- Drain the transfer oil. (See TRANSFER OIL REPLACEMENT [FW6AX-EL, GW6AX-EL] .)
- Remove the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
- Remove the transfer oil seal (RH) No. 1. (See Transfer Oil Seal (RH) No. 1 .)
- Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (RH) No. 2 as shown in the figure and remove the oil seal (RH) No. 2.
- Using the SST and a hammer, tap the new seal into place.
- Apply the lip of the oil seal with transfer oil.
- Install the transfer oil seal (RH) No. 1. (See Transfer Oil Seal (RH) No. 1 .)
- Install the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
- Add the specified amount and type of oil. (See TRANSFER OIL REPLACEMENT [FW6AX-EL, GW6AX-EL] .)