DTC P0602-00: Pcm Programming Error: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P0602:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0602:00	PCM programming error
DETECTION CONDITION	No configuration data in the PCM. Diagnostic support note This is a continuous monitor (CCM). The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA/Snapshot data is available. DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	Not applicable
POSSIBLE CAUSE	Configuration has not been completed PCM connector or terminals malfunction PCM malfunction
SYSTEM WIRING DIAGRAM	Not applicable