DTC P0524-00: Engine Oil Pressure Too Low: Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0524:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0524:00 |
Engine oil pressure too low |
| DETECTION CONDITION |
- 3 s have elapsed while the actual measured value of the engine oil pressure is lower than the threshold after 10 s have elapsed since the engine was started.
Diagnostic support note
- This is a continuous monitor (other).
- The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
- Restricts the upper limit of the engine speed.
- Restricts engine load.
|
| POSSIBLE CAUSE |
- Engine oil leakage
- Improper engine oil level
- Engine oil pressure sensor/engine oil temperature sensor connector or terminals malfunction
- PCM connector or terminals malfunction
- Engine oil pressure sensor malfunction
- Oil pump malfunction
- PCM malfunction
|
| SYSTEM WIRING DIAGRAM |
|