DTC P0500-00: VSS Circuit Problem: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P0500:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0500:00	VSS circuit problem
DETECTION CONDITION	An error in the wheel speed signal from the DSC HU/Control Module is detected by CAN when the following conditions are met: Shift position: except P or N position Absolute load: above 40 % Engine speed: above 2, 000 rpm Brake switch: OFF Diagnostic support note This is a continuous monitor (CCM). The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM. PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle. FREEZE FRAME DATA/Snapshot data is available. DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	Fixes the vehicle speed for the control at 0 km/h {0 mph}.
POSSIBLE CAUSE	DSC HU/Control Module malfunction Front ABS wheel-speed sensor malfunction PCM malfunction
SYSTEM WIRING DIAGRAM	Not applicable

CAUTION:

Verify the malfunction symptom according to not only the PID value but also the symptom troubleshooting.