LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (On-Board Diagnostic - Engine Control (VIN Y) (2 Of 3)) >> DTC P0401-00: EGR Flow Insufficient Detected >> PID Item/Simulation Item Used In Diagnosis >> PID/DATA monitor item table

PID/DATA monitor item table

WARNING: This page is about a different variant/trim than selected.
PID/DATA MONITOR PART SPECIFICATION

Item Definition Unit Condition/Specification
MAF Mass air flow input from MAF sensor g/Sec
  • Displays MAF
MAF sensor voltage V
  • Ignition switched ON (engine off) (MAF: 0.65 g/s {0.086 lb/min}): Approx. 0.72 V
  • Idle (after warm up) (MAF: 2.78 g/s {0.368 lb/min}): Approx. 0.86 V
  • Racing (engine speed is 2, 000 rpm) (MAF: 7.74 g/s {1.02 lb/min}): Approx. 1.14 V
MAP Manifold absolute pressure input from MAP sensor KPa {MPA}, mBar {BAR}, psi, in H20
  • Displays MAP
MAP_V MAP sensor voltage V
  • Ignition switched ON (engine off) (MAP:101 kPa {1.03 kgf/cm2 , 14.6 psi}): Approx. 1.81 V
  • Idle (after warm up) (MAP: 33 kPa {0.34 kgf/cm2 , 4.8 psi}): Approx. 0.91 V
  • Racing (engine speed is 2, 000 rpm) (MAP: 26 kPa {0.27 kgf/cm2 , 3.8 psi}): Approx. 0.83 V
scientia non olet · About LEMON Manuals